Smc-networks 48-Port Manual do Utilizador Página 1

TigerSwitch 10/10048-Port Fast Ethernet Switch◆ 48 10BASE-T/100BASE-TX ports◆ Optional 100BASE-FX or 1000BASE-SX modules◆ 13.6 Gbps of aggregate ba

COMPLIANCESivWichtige Sicherheitshinweise (Germany)1. Bitte lesen Sie diese Hinweise sorgfältig durch.2. Heben Sie diese Anleitung für den späteren

vTABLE OF CONTENTS1 About the TigerSwitch 10/100 1-1Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-1Switch

TABLE OF CONTENTSvi100 Mbps Fast Ethernet Collision Domain . . . . . . . . . . . 2-7SMC 3-2 Rule for Class II Repeaters . . . . . . . . . . . . 2-7

TABLE OF CONTENTSviiCables B-1Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .B-1Twisted-Pair Cable and Pin As

TABLE OF CONTENTSviii

1-1CHAPTER 1ABOUT THETIGERSWITCH 10/100OverviewSMC’s TigerSwitch™ 10/100 is a Fast Ethernet switch with 48 10BASE-T/100BASE-TX ports, plus two slots f

ABOUT THE TIGERSWITCH 10/1001-2Figure 1-2. Rear Panel Figure 1-3. Optional 100BASE-FX and 1000BASE-SX ModulesSwitch ArchitectureThe TigerSwitch empl

ABOUT THE TIGERSWITCH 10/1001-3Management OptionsThis switch contains a comprehensive array of LEDs for “at-a-glance” monitoring of network and port s

ABOUT THE TIGERSWITCH 10/1001-4Status LEDs The LEDs, which are located on the front panel for easy viewing, are shown below and described in the follo

ABOUT THE TIGERSWITCH 10/1001-5Network Management Module Figure 1-4. Network Management ModuleThis switch includes a Network Management Module on the

ABOUT THE TIGERSWITCH 10/1001-6Spanning Tree ProtocolThe TigerSwitch 10/100 supports IEEE 802.1D Spanning Tree Protocol. This protocol adds a level of

ABOUT THE TIGERSWITCH 10/1001-7Multicast SwitchingSpecific multicast traffic can be assigned to its own VLAN to ensure that it does not interfere with

ABOUT THE TIGERSWITCH 10/1001-8Figure 1-6. Single-Port 1000BASE-SX Module (SMC6900G)Using fiber optic cable, the 1000BASE-SX port can be connected to

ABOUT THE TIGERSWITCH 10/1001-9Figure 1-7. Power Supply ReceptaclesFeatures and BenefitsConnectivity◆ 48 dual-speed ports for easy Fast Ethernet inte

ABOUT THE TIGERSWITCH 10/1001-10Performance◆ Transparent bridging ◆ Aggregate bandwidth up to 13.6 Gbps◆ Switching Table with 12K MAC address entries◆

2-1CHAPTER 2NETWORK PLANNINGIntroduction to SwitchingA network switch allows simultaneous transmission of multiple packets via non-crossbar switching.

NETWORK PLANNING2-2Sample ApplicationsThe TigerSwitch 10/100 is not only designed to segment your network, but also to provide a wide range of options

NETWORK PLANNING2-3Central Wiring ClosetWith up to 52 ports on the switch, the TigerSwitch 10/100 can collapse a complex network down into a single ef

NETWORK PLANNING2-4Remote Connections with Fiber CableFiber optic technology allows for longer cabling than any other media type (up to 2 kilometers f

NETWORK PLANNING2-5Making VLAN ConnectionsVLANs can be based on port groups, or each data frame can be explicitly tagged to identify the VLAN group it

6 HughesIrvine, CA 92618Phone: (949) 707-2400TigerSwitch 10/100Installation GuideFrom SMC’s Tiger line of feature-rich workgroup LAN solutionsDecember

NETWORK PLANNING2-6Connectivity RulesWhen adding hubs (repeaters) to your network, please follow the connectivity rules listed below for Ethernet, Fas

NETWORK PLANNING2-7100 Mbps Fast Ethernet Collision DomainSMC 3-2 Rule for Class II RepeatersSMC 2-1 Rule for Class I Repeaters Maximum Network Diamet

NETWORK PLANNING2-810 Mbps Ethernet Collision DomainSMC 5-4-3 Rule Maximum Ethernet Cable Distance Between any two PCs or other stations in the same 1

NETWORK PLANNING2-9Application Notes1. Full-duplex operation only applies to point-to-point access (such as when a switch is attached to a workstation

NETWORK PLANNING2-10

3-1CHAPTER 3INSTALLING THE SWITCHSelecting a SiteTigerSwitch 10/100 units can be mounted in a standard 19-inch equipment rack or on a flat surface. Be

INSTALLING THE SWITCH3-2Equipment ChecklistAfter unpacking the TigerSwitch 10/100, check the contents to be sure you have received all the components.

INSTALLING THE SWITCH3-3MountingA TigerSwitch 10/100 unit can be mounted in a standard 19-inch equipment rack or on a desktop or shelf. Mounting instr

INSTALLING THE SWITCH3-4To rack-mount devices:1. Attach the brackets to the device using the screws provided in the Bracket Mounting Kit.Figure 3-1.

INSTALLING THE SWITCH3-53. If installing a single switch only, turn to “Connecting to a Power Source” at the end of this chapter.4. If installing mult

Information furnished by SMC Networks, Inc. (SMC) is believed to be accurate and reliable. However, no responsibility is assumed by SMC for its use, n

INSTALLING THE SWITCH3-6Connecting to a Power SourceTo connect a device to a power source:1. Insert the power cable plug directly into the receptacle

4-1CHAPTER 4MAKING NETWORKCONNECTIONSConnecting Network DevicesThe TigerSwitch 10/100 is designed to interconnect multiple segments (or collision doma

MAKING NETWORK CONNECTIONS4-2Connecting to PCs, Servers, Hubs and Switches1. Attach one end of a twisted-pair cable segment to the device’s RJ-45 conn

MAKING NETWORK CONNECTIONS4-3Wiring Closet ConnectionsToday, the punch-down block is an integral part of many of the newer equipment racks. It is actu

MAKING NETWORK CONNECTIONS4-4Fiber Optic DevicesAn optional slide-in 100BASE-FX module may be used for backbone and long distance connections. A 1000B

MAKING NETWORK CONNECTIONS4-5Figure 4-3. Making SC Port Connections4. As a connection is made, check the Activity LED on the switch’s front panel for

MAKING NETWORK CONNECTIONS4-6

A-1APPENDIX ATROUBLESHOOTINGDiagnosing Switch Indicators Troubleshooting ChartSymptom ActionPower LED is Off • Internal or redundant power supply has

TROUBLESHOOTINGA-2Power and Cooling ProblemsIf the power indicator does not turn on when the power cord is plugged in, you may have a problem with the

TROUBLESHOOTINGA-3Note: You can configure the management agent to accept from one to four simultaneous Telnet sessions. If the maximum number of sessi

LIMITED WARRANTYLimited WarrantyLimited Warranty Statement: SMC Networks, Inc. (“SMC”) warrants its products to be free from defects in workmanship an

TROUBLESHOOTINGA-4

B-1APPENDIX BCABLESSpecifications Note: If you need to connect to a device with 62.5/125 micron cable that has ST-type connectors, SMC provides an opt

CABLESB-2Twisted-Pair Cable and Pin AssignmentsCaution: DO NOT plug a phone jack connector into any RJ-45 port. Use only twisted-pair cables with RJ-4

CABLESB-3100BASE-TX/10BASE-T Pin AssignmentsWith 100BASE-TX/10BASE-T cable, pins 1 and 2 are used for transmitting data, and pins 3 and 6 for receivin

CABLESB-4Crossover WiringIf the twisted-pair cable is to join two ports and either both ports are labeled with an “x” (MDI-X) or neither port is label

CABLESB-5Console Port Pin AssignmentsThe DB-9 serial port on the switch’s rear panel is used to connect to the switch for out-of-band console configur

CABLESB-6DB-9 Port Pin AssignmentsConsole Port to 9-Pin COM Port on PCConsole Port to 25-Pin DCE Port on ModemEIA CircuitCCITT SignalDescription Switc

CABLESB-7Console Port to 25-Pin DTE Port on PCSwitch’s 9-Pin Serial PortNull Modem PC’s 25-Pin DTE Port1 DCD 8 DCD2 RXD 3 TXD3 TXD 2 RXD4 DTR 20 DTR5

CABLESB-8

C-1APPENDIX CSPECIFICATIONSPhysical CharacteristicsPorts48 10BASE-T/100BASE-TX, with auto-negotiation2 slots for optional dual-port 100BASE-FX or sing

LIMITED WARRANTYOF ALL OTHER WARRANTIES OR CONDITIONS, EXPRESS OR IMPLIED, EITHER IN FACT OR BY OPERATION OF LAW, STATUTORY OR OTHERWISE, INCLUDING WA

SPECIFICATIONSC-2Weight9.92 lbs (4.5 kg)Size17.37 x 13.38 x 3.46 in (44.0 x 35.3 x 8.8 cm)TemperatureOperating: 32 to 122°F (0 to 50°C)Storage: -40 to

SPECIFICATIONSC-3Switch FeaturesSpanning Tree ProtocolForwarding ModeStore-and-forwardThroughputWire speedFlow ControlFull Duplex: IEEE 802.3xHalf Dup

SPECIFICATIONSC-4Management FeaturesIn-Band ManagementTelnet, Web-based HTTP, or SNMP manager(EliteView Network Management software provided for free)

SPECIFICATIONSC-5StandardsIEEE 802.3 EthernetIEEE 802.3u Fast Ethernet IEEE 802.3z Gigabit EthernetIEEE 802.1D Spanning Tree ProtocolIEEE 802.1p prior

SPECIFICATIONSC-6WarrantyLimited lifetime

SPECIFICATIONSC-7Slide-in Module100BASE-FX Extender ModuleModelSMC6900FSC, SMC6900FSTPorts2 100BASE-FXNetwork InterfaceSC connector, 50/125 or 62.5/12

SPECIFICATIONSC-8Network Management ModuleModelSMC6948NMMPortsRS-232 console port

D-1APPENDIX DORDERING INFORMATIONTigerSwitch 10/100 Products and AccessoriesProduct Number DescriptionSMC6948L2 48-port Fast Ethernet Switch with two

ORDERING INFORMATIOND-2

Glossary-1GLOSSARY10BASE-TIEEE 802.3 specification for 10 Mbps Ethernet over two pairs of Category 3, 4, or 5 UTP cable.100BASE-FXIEEE 802.3u specific

iCOMPLIANCESFCC - Class AThis equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the

GLOSSARYGlossary-2Class I RepeaterFast Ethernet repeater that is principally used to connect different physical signaling systems (e.g., 100BASE-TX, 1

GLOSSARYGlossary-3EthernetA network communication system developed and standardized by DEC, Intel, and Xerox, using baseband transmission, CSMA/CD acc

GLOSSARYGlossary-4IEEE 802.3uDefines CSMA/CD access method and physical layer specifications for 100BASE-TX Fast Ethernet. IEEE 802.3xDefines Ethernet

GLOSSARYGlossary-5MIBAn acronym for Management Information Base. It is a set of database objects that contains information about the device.MIIMedia I

GLOSSARYGlossary-6

Index-1Numerics10 Mbps connectivity rules 2-8100 Mbps connectivity rules 2-71000 Mbps connectivity rules 2-61000BASE-SXconnections 4-4fiber cable leng

INDEXIndex-2features C-3management 1-10switch 1-9fiber cables 4-4flow control, IEEE 802.3x 1-3front panel of switch 1-1full-duplex connectivity 2-1GGi

INDEXIndex-3optional equipment D-1ordering information D-1out-of-band management 1-3, 1-5Ppackage contents 3-2pin assignments B-2100BASE-TX/10BASE-T B

INDEXIndex-4UUL compliance iiiVVCCI compliance iiVLANs 1-5, 1-6, 2-5tagging 2-5Wwarranty C-6Web-based management 1-3Weighted Fair Queuing 1-7

COMPLIANCESiiIndustry Canada - Class AThis digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus as se

6 HughesIrvine, CA 92618Phone: (949) 707-2400FOR TECHNICAL SUPPORT, CALL:From U.S.A. and Canada (8:30 AM - 8:00 PM Pacific Time)(800) SMC-4-YOU; (949)

COMPLIANCESiiiSafety ComplianceWarning: Fiber Optic Port SafetyAvertissment: Ports pour fibres optiques - sécurité sur le plan optiqueWarnhinweis: Fas