SMC Networks SMC8013WG Manual do Utilizador descarregar pdf (Página 21)

Configuring a Predefined Filtering Access Rule:

1. On the Side Navigation bar, click on [Firewall] then select [Access Control]

2. Under the Predefined Section, click on the [Add] button

3. On the next page, select the service that you want to block from the pull-down menu

4. Select the [LAN IPs] that you want this access rule to apply to. You can choose to apply

this rule to Any IP Address, a Single IP Address, or a Range of IP Addresses.

If you choose [Any] for the LAN IPs you don’t need to configure the [Start IP] or [End IP]

options.

If you choose [Single address] enter in the LAN IP address of the PC into the [Start IP]

section.

If you choose [Address Range] enter in the starting LAN IP address in the [Start IP]

section and enter in the ending LAN IP address of the range you want in the [End IP]

section.

5. When your configuration is complete, click the [Apply] button to save your changes and

return to the main Access Control page.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 39 40

Sem comentários

SMC Networks SMC8013WG Manual do Utilizador Página 21