Smc-networks SpacePC 1232 Series Manual do Utilizador descarregar pdf (Página 30)

IDE Led

JP10

Figure 16. J9 and JP10 Connectors layout

To install the hard disk, perform the following operations:

¾ Hardware installation. Connect the hard disk to the module using a data cable, and then

connect the hard disk to the power supply respecting the device’s specifications. Make sure

that pin 1 of connector J9 and pin 1 of the drive or drives are correctly connected. Pin 1 of the

interface cable is usually indicated by a stripe along the edge of the cable. If two hard disks

need to be connected, they must be configured for common operation (i.e. master/slave or

cable select connection).

¾ IDE BIOS Setup. The hard disk parameters can be configured using the Setup program. If

the hard disk is connected to the module without setup configuration or with a wrong setup

configuration, a time-out for a few minutes occurs, then the boot is performed from the floppy

disk.

¾ Software initialization for specific operating systems. Refer to the OS documentation.

JP10 IDE LED Connector

The IDE HDD activity LED output is implemented on connector JP10.

This is a 2-pin connector with 2-mm pitch header.

To this connector is possible to connect a led that display the IDE activity.

Check the pin out and pin functions on the following table:

Table 14. JP10 IDE LED Connector

Pin Signal Function

Ground IDE LED anode (-)

IDELED (+) IDE LED cathode (+)

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 86 87

Sem comentários

Smc-networks SpacePC 1232 Series Manual do Utilizador Página 30