SMC Networks SMC8014W-G Manual do Utilizador descarregar pdf (Página 50)

APPENDIX A | Telnet and SSH CLI Commands

Refer to the Remote Management section in Chapter 6 to enable and configure Telnet and

SSH settings.

Refer to the 8014 CLI document for command specifics.

To remotely access the CLI of the SMC8014W-G via Telnet, open a DOS/Command Prompt

and type: telnet IP remote mgmt port Enter

• NOTE: Telnet remote management is not enabled by default. To enable, first log into

the Gateway via the HTTP web admin page and go to System/Remote Management and

select the check box next to Telnet Port

• For example, open a command prompt and type: telnet

xxx.xxx.xxx.xxx 2323 Enter

(where xxx.xxx.xxx.xxx is your WAN IP listed on the status page)

• Enter the same user and password as used for the GUI/HTTP

• Commands are case sensitive

• Type help and then Enter for a list of commands

Use an SSH client of your choice for SSH remote management.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 59 60

Sem comentários

SMC Networks SMC8014W-G Manual do Utilizador Página 50