SMC Networks SMC8606T Manual do Utilizador descarregar pdf (Página 15)

WITCH

ANAGEMENT

1-3

Remote Management via the Console Port

Configure the Switch Site

Connect the switch’s DB9 serial port to the modem’s serial port

using standard cabling. For most modems which use a 25-pin port,

you will have to provide an RS-232 cable with a 9-pin connector on

one end and a 25-pin connector on the other end. Set the modem

at the switch’s site to force auto-answer mode. The following is a

sample initialization string: “ATQ1S0=1&D0&K0&W” as defined

below:

Q1 : Inhibit result codes to DTE

S0=1 : Auto answer on first ring

D0 : Don’t care DTR

K0 : Disables DTE/DCE flow control

W : Write command to modem memory

Configure the Remote Site

At the remote site, connect the PC’s COM port (COM 1~4) to the

modem’s serial port. Set terminal emulation type to VT100, specify

the port used by your PC (i.e., COM 1~4), and then set

communications to 8 data bits, 1 stop bit, no parity, 19200 bps and

no flow control.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 181 182

Sem comentários

SMC Networks SMC8606T Manual do Utilizador Página 15