Smc-networks TIGERSWITCH 10/100 Manual do Utilizador descarregar pdf (Página 146)

OMMAND

INE

NTERFACE

3-4

Entering Commands

This section describes how to enter CLI commands.

Keywords and Arguments

A CLI command is a series of keywords and arguments. Keywords

identify a command, and arguments specify configuration

parameters. For example, in the command “show interfaces status

ethernet 1/5,” show interfaces and status are keywords,

ethernet is an argument that specifies the interface type, and 1/5

specifies the unit/port.

You can enter commands as follows:

• To enter a simple command, enter the command keyword.

• To enter multiple commands, enter each command in the

required order. For example, to enable Privileged Exec

command mode, and display the startup configuration, enter:

Console>enable

Console#show startup-config

• To enter commands that require parameters, enter the required

parameters after the command keyword. For example, to set a

password for the administrator, enter:

Console(config)#username admin password 0 smith

Minimum Abbreviation

The CLI will accept a minimum number of characters that uniquely

identify a command. For example, the command “configure” can

be entered as config. If an entry is ambiguous, the system will

prompt for further input.

1 2 ... 141 142 143 144 145 146 147 148 149 150 151 ... 317 318

Sem comentários

Smc-networks TIGERSWITCH 10/100 Manual do Utilizador Página 146