Smc-networks TIGERSWITCH 10/100 Manual do Utilizador descarregar pdf (Página 291)

IRROR

ORT

OMMANDS

3-149

Default Setting

No mirror session is defined. When enabled, the default

mirroring is for both received and transmitted packets.

Command Mode

Interface Configuration (Ethernet, destination port)

Command Usage

• You can mirror traffic from any source port to a destination port

for real-time analysis. You can then attach a logic analyzer or

RMON probe to the destination port and study the traffic

crossing the source port in a completely unobtrusive manner.

• The destination port is set by specifying an Ethernet interface.

• The mirror port and monitor port speeds must match, otherwise

traffic may be dropped from the monitor port.

• You can create multiple mirror sessions, but all must share the

same destination port. However, you should avoid sending too

much traffic to the destination port from multiple source ports.

Example

The following example configures the switch to mirror all packets

from port 6 to port 11:

show port monitor

Use this command to display mirror information.

Syntax

show port monitor [interface]

interface - ethernet unit/port (source port)

• unit - Switch (unit 1).

• port - Port number.

Console(config)#interface ethernet 1/11

Console(config-if)#port monitor ethernet 1/6 both

Console(config-if)#

1 2 ... 286 287 288 289 290 291 292 293 294 295 296 ... 317 318

Sem comentários

Smc-networks TIGERSWITCH 10/100 Manual do Utilizador Página 291